Holly Nozzle Head

Holly Snow Lance replacement nozzle head.

• Output: 200l/hour
• Starting temperatur: -0.8°C wet bulb
• Water pressure range: 3.8 - 8 bar
• Air consumption: 100l/min at 4 bar

This nozzle head works seamlessly with existing Holly snow lances.
Installation steps:

1. Open the old nozzle head two rear covers.
2. Dismount the existing two water ducts at the connection pieces as well as the air duct directly on the top of nucleator nozzle.
3. Pull out the central mounting screw at the bottom of the nozzle head and remove it. Remove the head and pull out the supply ducts.
4. Install the new nozzle head by following the previous steps in opposite order. Make sure that the central duct coming out of the control housing (water 1) is connected to the y-piece inside the nozzle head. This is the distributor for the first stage. This way, the nucleator nozzle as well as the 6 bottom nozzles are active at the same time.